Owner`s manual

Remove contents from box. Remove the foam separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there
should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 3 for charging information).
BEFORE YOU BEGIN
WARNING:
DO NOT USE NON-
RAZOR PRODUCTS
WITH YOUR RAZOR
ELECTRIC SCOOTER.
The scooter has been built
to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the
basis of its compatibility with
the frame, fork and all other
parts. Certain aftermarket
products may not be compatible
and will void the warranty.
Required Tools
5mm Allen wrenches
(Included)
Brake
Push Button Throttle
Handlebar
Stem
On/Off Switch
Charger Port
- Battery
- Control Module
Limiter
Charger
(Note: Charger design may vary
from one shown)
Charger
Plug
Charger
Port
10mm and 13mm open
wrenches
(Not included)
Screwdriver
(Not included)
Motor
Note: Electric scooter must
be moving at 3mph/5kmh
while pressing the push
button throttle to engage
motor.
Product ID Locations:
See locations to the left
1. Stem
2. Underneath battery tray
3. Charger
4. Box - side of UPC (not shown)
1.
2.
3.