e90/acceleratOr series electric scOOter NOTE: The unit must be traveling up to 3mph (5kmh) before motor will engage. Kick start up to 3mph (5kmh) while applying the throttle to engage motor. Owner’s Manual Read and understand this entire manual before riding! DO NOT RETURN TO STORE! NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice.
SafETy WaRNINgS WaRNINg: Riding an electric scooter does present potential risks and caution is required. Like any riding product, an electric scooter has inherent hazards associated with its use (for example, falling off or riding it into a hazardous situation). Like any riding product, electric scooters can and are intended to move and it is therefore, of course, possible to lose control or otherwise get into dangerous situations.
BEfORE yOU BEgIN Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
aSSEMBLy aND SET-UP q attaching the Handlebar grip 1 Insert and secure the collapsible handlebar by pressing the spring-loaded button and inserting it into the T-bar. WaRNINg: Failure to properly engage the spring-loaded button may cause the handlebar to dislodge while riding and may cause you to lose control and fall. When correctly engaged, the handlebar will not rotate nor will it move sideways. Note that when properly engaged, the spring-loaded button is clearly visible in the hole on the T-tube.
USagE q Starting the Scooter Note: Electric scooter must be moving at 3mph/5kmh while pressing the push button throttle to engage motor. To start unit, turn on the power switch, press the push button throttle (A) and kick start up to 3mph (5kmh) (B). q Stopping the Scooter To stop unit, release the push button throttle (A) and step down on the rear fender brake (B) until the unit comes to a complete stop.
REPaIR aND MaINTENaNCE q front Wheel Replacement Tools required: Two (2) 5mm Allen wrenches. Note: Front wheel hardware sequence 1 Using two (2) 5mm Allen wrenches, loosen the axle bolt. Remove wheel and install replacement wheel.
REPaIR aND MaINTENaNCE q Battery Care and Disposal Never store the product in freezing or below freezing temperatures! Freezing will permanently damage the battery. Failure to recharge the battery at least once a month may result in a battery that will no longer accept a charge. CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED. Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally safe manner.
TROUBLESHOOTINg gUIDE Problem Possible Cause Solution Does not work out of the box Unit must be traveling up to 3mph before motor will engage Kickstart to 3mph while pressing the push button throttle to engage motor. Loose connection(s) Check for loose connections/wires underneath the deck plate. Blown fuse Check fuse; replace if needed. Loose connection(s) Check for loose connections/wires underneath the deck plate. No lights on charger Check power to wall outlet and/or try a different outlet.
E90 ELECTRIC SCOOTER PaRTS 01 Elastic cord w/end cap 12 Charger port 02 Handlebar grips (right/left) 13 Kickstand 03 Push button throttle 14 Brake fender pedestal 04 Handlebar stem 15 Chain tensioner 05 Collar clamp 16 Motor (12V / 100W) 06 Headset (upper/lower) 17 Rear brake fender 07 Front fork w/limiter 18 Rear wheel complete 08 Front wheel complete (See pg. 5 for hardware sequence) (See pg.
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. WaRRaNTy Razor Limited Warranty The manufacturer warranties this product to be free of manufacturing defects for a period of 90 days from date of purchase.
