User Manual

7
REPAIR AND MAINTENANCE
q Chain and Sprocket
The chain will typically have a “loose spot” and “tight spot” corresponding with a particular sprocket rotational
position. This is normal and common to all chain-driven products due to run-out tolerances of the freewheel and
sprocket. Proper chain alignment must be maintained. If the chain is noisy or rough running, check the lubrication,
tension and alignment of the sprockets, in that order. The chain tensioner must be aligned and free from binding and
the tensioner spring(s) must be operating correctly.
q Battery Care and Disposal
Do not store in freezing or below freezing temperatures. To properly maintain your battery and ensure maximum
battery life, carefully read the “Charging the Battery” section on page 4 of this owner’s manual.
CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED.
Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an
environmentally safe manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not
dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-
acid batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or state
approved lead-acid battery recycler or a local seller of automotive batteries. If you live in Florida or Minnesota, it is
prohibited by law to throw away lead-acid batteries in the municipal waste stream.
q Charger
The charger supplied with the electic four wheeler should be regularly examined for damage to the cord, plug,
enclosure and other parts, and, in the event of such damage, the Dirt Quad must not be charged until it has been
repaired or replaced.
Use ONLY with the recommended charger.
q Replacement Parts
For a complete selection of parts, visit www.razor.com.
q Repair Centers
For a list of authorized Razor Service Centers:
• Check online at www.razor.com.
• Call 866-467-2967 for Customer Service assistance.
8 Position bottom half of the
chain guard to align mounting holes
and screw to frame.
9 Position top half of the chain
guard to align mounting holes and
screw to frame.
7 Reset chain tensioner.
11 On the outside of the wheel
replace washers and secure with
bolt.
10 On the inside of the wheel
slide bolt through wheel and axle
and secure with nut.
WARNING:
To avoid a pinch or injury, keep
fingers away from moving sprockets
and chain.
WARNING:
If a battery leak develops, avoid
contact with the leaking acid and
place the damaged battery in a
plastic bag. Refer to the disposal
instructions at left. If acid comes
into contact with skin or eyes, flush
with cool water for at least 15
minutes and contact a physician.