User Manual

37-44
mm
37-44
mm
5
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the bottom of the frame) available for better assistance.
REPAIR AND MAINTENANCE
q Stopping the Dirt Quad
To stop unit, release the throttle and apply the brake until
the unit comes to a complete stop.
Turn power switch OFF before conducting any maintenance procedures.
WARNING:
The brake is capable of causing the
electric four wheeler to skid the
tire throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding
to a stop as this can cause you to
lose control or damage the rear
tire(s).
1 To adjust the tension, thread
the brake lever adjuster in or out
1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2 for
rear brake.
USAGE
2 Locate the rear brake caliper and
disk brake behind the right rear
wheel. The distance of the brake
wire between the end of the cable
and the anchor bolt should be
between 37 and 44 mm. If the rear
brake has too much slack, loosen
the rear anchor bolt with a 5mm
Allen wrench and pull the brake
wire tighter (direction indicated
with arrow).
3 If the brake rotor is
dragging on the brake pads
use your fingers to twist the caliper
adjuster in either
direction until rotor is
centered between pads.
Backside
view of
disk brake
Rotor
Pads
Caliper adjuster
q Adjusting the Brake
Tools required: 5mm Allen wrench
WARNING: Failure
to recharge the battery at least
once a month may result in a
battery that will no longer hold
a charge.
q Starting the Dirt Quad
To start unit, turn on power switch; place both hands on
handlebars and apply the throttle with right hand.