User Manual

3
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the bottom of the frame) available for better assistance.
1 Using the 6mm Allen wrench,
remove bolts from handlebar
clamp.
Note: Handlebar clamps are
located in the plastic bag with
owner’s manual and charger.
2 Place handlebars in handlebar
clamp in upright, vertical position.
3 Insert bolts and tighten
securely. When properly tightened,
the handlebars
should not move forward or back.
Note: The gap between the upper
clamp and lower clamp should be
equal on both sides of handlebar.
q Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and your
purchase. Inflate the tires to the correct PSI before first time use.
Lower air pressure can result in a shorter ride time.
Periodically check all four tires. Reinflate when needed.
Note:
The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your tires, first make sure the
pressure gauge is working, then
use very short bursts to inflate to
the correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.
Using a bicycle tire pump equipped for a Schrader valve, inflate the tires to the PSI indicated on the sidewall of the tire.
q Testing the Brake
To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fitted with a cable
adjuster to compensate for cable stretch and/or to fine-tune the lever movement to brake engagement. If brake is not
engaging properly, follow instructions for adjusting the brakes outlined on page 5.
WARNING:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to lose
control and crash.
q Attaching the Handlebars
Tools required: 6mm Allen wrench
ASSEMBLY AND SET-UP