User Manual

2
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the bottom of the frame) available for better assistance.
BEFORE YOU BEGIN
Remove contents from box. Remove the cardboard separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred
during shipping. Because the Dirt Quad is 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 20 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 4 for charging information).
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
DIRT QUAD. The Dirt Quad
has been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may or may
not be compatible and may void
your warranty.
Product ID Locations:
1. Footstep (right side)
2. Charger
3. Box (not shown)
4. Bottom of the Frame
(underneath the unit)
Required Tools
3mm, 5mm and 6mm
Allen wrenches
(included)
Brake Lever
Throttle
Phillips
screwdriver
(included)
8mm and 10mm
wrenches
(included)
Bicycle tire pump for Schrader
valves, with pressure gauge
(Not Included)
Charger
(Note: Charger design may vary
from one shown)