User Manual

ON
OFF
ON
OFF
ON
OFF
ASSEMBLY AND SET-UP
Installing Remote Batteries
Tool Required: Phillips Screwdriver
Remote Pairing Confirmation
Note: Your remote should have been paired with your RazorX DLX Electric Skateboard at the factory.
1 Loosen Phillips screw on battery
cover and remove cover.
1 Turn the power switch on the
remote to the ON position.
2 Install two (2) AAA batteries.
1 Turn the power switch on the
remote to the OFF position.
3 Re-attach battery cover
and securely tighten in place
with screw.
2 Press and hold power button on
the product to the ON position.
If the power button on the product
is solid red, then the product has
been successfully paired at the
factory and no further steps are
needed.
3 If power button on product
is flashing, leave power button
on the product in the ON position.
See Pairing the Remote section
below for pairing instructions.
Pairing the Remote
2 Press and hold power button
for five seconds it will start to flash
quickly.
4