User Manual

Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches, or dents that may have occurred during shipping. Because the RazorX DLX Electric
Skateboard was 99% assembled and packed at the factory, there should not be any problems, even if the box has a few
scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 5 hours for charge (see page 6 for charging information).
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RAZORX DLX
ELECTRIC SKATEBOARD.
The RazorX DLX Electric Skate-
board has been built
to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the
basis of its compatibility with
the frame and all other parts.
Certain aftermarket products
may not be compatible and will
void the warranty.
Note: RazorX DLX Electric
Skateboard must be moving
at least 3 mph (5 km/h) while
holding the lever on the remote
in the “GO” position for motor
to engage.
Product ID Locations:
(See locations to the left)
1. Underneath Deck
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• RazorX DLX Electric Skateboard
• Remote
• Two (2) AAA Batteries
• Charger
• Owner’s Manual
Wheel
1. Barcode
Remote
2.
Charger Port
Power Button
LED Indicator
Charger
(Note: Charger design may
vary from one shown)
BEFORE YOU BEGIN
Hub Motor
Battery
3