User Manual

4
ASSEMBLY AND SET-UP
Turn power switch OFF before conducting any maintenance procedures.
Attaching the Front Wheel/Handlebars
Tool Required: 5 mm Allen wrench
1 Remove and discard plastic cap
3 Slide the headset cover up. Depress the spring loaded
button on the T-bar and insert the T-bar into the front fork
until the T-bar is securely locked into place.
5 Connect the black connector on the T-bar to the black
connection on the down tube.
6 Slide headset cover all the way down to cover collar
clamp and connectors.
2 Loosen the 5 mm bolt on the collar clamp.
4 With the front wheel pointed straight ahead, the
handlebars square to the front wheel and the Razor logo
on the T-bar facing the front, tighten the bolt on the collar
clamp. Tighten securely.
Note: Failure to secure the
handlebars can cause the
handlebars to come out while riding.
WARNING: Failure
to properly tighten the collar
clamp may cause the rider to
lose control and fall. If you are
having difficulty understanding
these instructions, please
contact Razor Customer Service
for assistance.