User Manual

2
Need Help? Visit our website for replacement parts and product support at www.razor.com or call toll-free at
866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Please have the product I.D. code (located on the
bottom of the frame) available for better assistance.
BEFORE YOU BEGIN
Remove contents from box and check parts against parts diagram found on page 6. Remove the separators that
protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint or
dents that may have occurred during shipping. Because the FlashRider 360˚ was partially assembled and packed at the
factory there should not be any problems, even if the box has a few scars or dents.
q Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly.
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR FLASHRIDER 360˚.
The FlashRider 360˚ has been
built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may be
compatible and will void your
warranty.
q Required Tools
Two (2) 5 mm
Allen wrenches
(included)
10 mm and 13 mm
wrench
(included)
PRODUCT I.D. CODE
1. Bottom of Frame
2. UPC Side of Box (not shown)
Front Fork Assembly
Front Wheel Assembly
Steering Bolt
Seat
Barcode
Location
Rear Caster Wheels
Spark Bar
Spark Cartridge
Spark Handle
Spark Cartridge Cover