Owners manual

5
Calibration Confirmation
Note: Your Hovertrax 1.5 should have been calibrated at the factory.
Calibrating Hovertrax 1.5
ASSEMBLY AND SET UP
1 Place Hovertrax 1.5 on a level surface.
1 Place Hovertrax 1.5 on a level surface.
4 Turn power back OFF.
2 Turn power ON. If product remains level or adjusts to become
level, calibration has been confirmed. No further steps are needed.
If product begins to roll or does not move into a level orientation,
see Calibrating Hovertrax 1.5.
2 Manually adjust the platforms so they are level to the ground.
3 While keeping the product level, turn power
ON and HOLD until product beeps and lights flash
(approximately 15-20 seconds).
5 Calibration complete.
Note: Once the product has been calibrated, no matter what
position (angle) the platforms are in when it is turned off, the
platforms will automatically self-balance themselves back to the
calibrated position when product is turned on.