Owners manual

4
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR PRODUCT.
The Hovertrax1.5 has been built to
certain Razor design specifications.
The original equipment supplied
at the time of sale was selected
on the basis of its compatibility
with the frame and all other parts.
Certain aftermarket components
may not be compatible and will
void the warranty.
Product ID Locations:
See locations to the left
1. Frame (Underneath Product)
2. Charger
3. Box - Side of UPC (Not Shown)
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches or dents that may have occurred during shipping. Because the Hovertrax1.5 was
assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. Please
keep this box in case you need to send the Hovertrax1.5 back for service or repairs. If you use another box, Razor will
not be responsible for any damage caused during shipping.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Estimated Set-Up Time
Allow up to 6 hours for initial charge (see page 6 for charging information).
BEFORE YOU BEGIN
Battery/Power
Mode Indicator
LED Lights
Rubber Tires
On/Off Button
Charger Port
1.
Anti-Slip Foot Platforms
2.
Charger
(Note: Charger design may
vary from one shown)
Box Contents:
• Hovertrax1.5
• Charger
• Owner’s Manual