User Manual
4
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR PRODUCT.
The Hovertrax2.0 has been built to
certain Razor design specifications.
The original equipment supplied
at the time of sale was selected
on the basis of its compatibility
with the frame and all other parts.
Certain aftermarket components
may not be compatible and will
void the warranty.
Product ID Locations:
See locations to the left
1. Frame (Underneath Product)
2. Charger
3. Box - Side of UPC (Not Shown)
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches, dents or kinked cables that may have occurred during shipping. Because the
Hovertrax2.0 was assembled and packed at the factory, there should not be any problems, even if the box has a few
scars or dents. Please keep this box in case you need to send the Hovertrax2.0 back for service or repairs. If you use
another box, Razor will not be responsible for any damage caused during shipping.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Estimated Set-Up Time
Allow up to 6 hours for initial charge (see page 5 for charging information).
BEFORE YOU BEGIN
Battery/Power
Mode Indicator
LED Lights
Rubber Tires
Gyro Sensors
On/Off Button
Charging Port
Anti-Slip Foot Platforms
2.
Charger
(Note: Charger design may
vary from one shown)
Box Contents:
• Hovertrax2.0
• Charger
• Owner’s Manual