HOVERTRAX™ 2.0 HOVERTRAX DLX™ 2.0 OWNER’S MANUAL Read and understand this entire manual before using this product! For assistance contact Razor. DO NOT RETURN TO STORE. NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice. Please have your product along with the 19 character product I.D. code with you before contacting Razor for warranty assistance and/or replacement parts.
CONTENTS Introduction....................................................................................................... 1 Safety Warnings............................................................................................2-3 Pre-Ride Checklist............................................................................................. 3 Before You Begin.............................................................................................. 4 Charging the Battery...........................
SAFETY WARNINGS WARNING: Whenever you ride the Hovertrax 2.0 you risk serious injury or death from collisions, falls or loss of control. To ride safely, YOU MUST READ AND FOLLOW THE INSTRUCTIONS AND WARNINGS IN THIS MANUAL. WARNING: Riding any electric product can be a hazardous activity. Certain conditions may cause the equipment to fail without fault of the manufacturer. Like other electric ride-on products, the Razor Hovertrax 2.
SAFETY WARNINGS USING THE CHARGER The charger supplied with the electric product should be regularly examined for damage to the cord, plug, enclosure and other parts. In the event of such damage, the product must not be charged until the charger has been repaired or replaced. Never use headphones or a cell phone when riding. Never hitch a ride with another product. Do not ride the Razor Hovertrax 2.
BEFORE YOU BEGIN Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect the contents of the box for scratches, dents or kinked cables that may have occurred during shipping. Because the Hovertrax 2.0 was assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. Please keep this box in case you need to send the Hovertrax 2.0 back for service or repairs.
CHARGING THE BATTERY Your Hovertrax 2.0 comes with a built-in Li (NiCoMn)O2 battery pack. Your Hovertrax 2.0 may not have a fully charged battery; therefore you must charge the battery prior to use. Be sure to charge the battery in a clean, dry location away from direct sunlight, flames or sparks. • Use only Razor Hovertrax 2.0 charger. • Initial charge time: 6 hours. • Recharge time: up to 4 hours, even if the light turns green. Recommended maximum charging time is 24 hours.
HOW TO OPERATE HOW IT WORKS The Hovertrax 2.0 responds to the rider's foot movements. Remember this. The Hovertrax 2.0 moves due to fore and aft foot platform tilt caused by the rider’s foot (or feet). Movement, speed, and stopping are controlled by the degree to which the rider’s feet cause the foot platforms of the Hovertrax 2.0 to no longer be parallel to the ground. Note: Do not lift the Hovertrax 2.0 off the ground when it is turned on. Do not turn on the Hovertrax 2.0 in mid-air.
HOW TO OPERATE HOW TO CHANGE MODES 1 Training mode is the default mode: POWER SWITCH IN ON POSITION Power switch in "ON" position Normal mode: 2 TRAINING MODE This start-up scenario would only appear after completing the "change the mode" section. Whatever mode the NORMAL POWER SWITCH POSITION Hovertrax 2.0 was leftINinON when turned off, will be the mode it begins in when turned backMODE on.
1 2 HOW TO OPERATE 1 1 Changing the mode: POWER SWITCH IN ON POSITION 23 4 POWER SWITCH IN ON POSITION TRAINING MODE PRESS ON SWITCH AGAIN Power switch in "ON" position 4 NORMAL MODE NORMAL MODE 2 3 5 TRAINING MODE POWER SWITCH IN ON POSITION PRESS ON SWITCH AGAIN READY TO GO 4 5 3 TRAINING MODE Training mode NORMAL MODE READY TO GO Push button twice 5 Normal mode READY TO GO Ready to use 8 2 3 TRAINING M PRESS ON SWITCH AGAIN PRESS ON SW 5 READY TO G
HOW TO OPERATE HOW TO GET ON Once you have charged the battery (see page 5 for charging information): 1. Power On: Set the Hovertrax 2.0 on the ground and turn the power on and the blue light on the power button will light-up. The battery/power mode indicator will show either one or two green lights to indicate mode (see page 8 for instructions on switching modes). Do NOT proceed to step two until all lights on the indicator light up. 2. First Foot: While standing behind the Hovertrax 2.
HOW TO OPERATE • Be alert. Scan both far ahead and in front of you - your eyes are your best tool for safely avoiding obstacles and slippery surfaces. • Hold your arms comfortably at your side. • Start at a slow and comfortable pace. Never aggressively accelerate or lunge forward. • Be careful and considerate of others. • Always ride under control at a speed that is safe for you and those around you. • Always be prepared to stop. • Respect pedestrians by always yielding the right of way.
REPAIR AND MAINTENANCE WARNING: Risk of fire–no user serviceable parts. Battery Care and Disposal To remove the quick change battery pack press firmly on the center of the pack while depressing tabs on both sides. Do not store in freezing or below freezing temperatures. To properly maintain your battery and ensure maximum battery life, carefully read the “Charging the Battery” section on page 5 of this owner’s manual. Li-io li-io CONTAINS LITHIUM ION BATTERY PACK. BATTERIES MUST BE RECYCLED.
HOVERTRAX PARTS Keep your Hovertrax 2.0 running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 1. 2. 3. 4. 5. Fender Bumper Protection Footplate (Left/Right) Top Cover w/LED (Right) Top Cover w/LED (Left) On/Off Switch 6. 7. 8. 9. 10. PC Board (Left/Right) Indicator Lights Torsion Bar Wheel w/ Hub Motor (x2) Bottom Cover (Left) 11. Charger Port 11-1. Charger Port Cover 12.
WARRANTY Razor Limited Warranty The manufacturer is not liable for incidental or consequential loss or damage due directly or indirectly to the use of this product. The manufacturer warranties this product to be free of manufacturing defects for a period of 90 days from date of purchase. This Limited Warranty does not cover normal wear and tear, tires, tubes or cables, or any damage, failure or loss caused by improper assembly, maintenance, storage or use of the Razor Hovertrax 2.0 and Hovertrax DLX 2.0.
CUSTOMER SERVICE CONTACT INFORMATION Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is listed below: AMERICAS EUROPE, MIDDLE EAST, AFRICA ASIA Razor USA LLC P.O.
