Owners manual

8
REPAIR AND MAINTENANCE
5 Install the new chain or wheel
by slipping the chain around the
axle bolt. Slide the axle bolt into the
slots on the frame. Slide the chain
tensioner down and maneuver the
chain onto the rear sprocket and
motor sprocket.
6 Re-attach the chain guard.
7 Re-attach the brake caliper to
the disc brake and tighten securely
in place with 5 mm bolts removed
in Step 1.
Chain and Rear Wheel Replacement
Tools Required: Phillips Screwdriver, 14 mm Wrench, 17 mm Wrench, 5 mm Allen Wrench.
3 Using a 14 mm and 17 mm
wrench, loosen the locknut and axle
bolt on the rear wheel.
4 Push the chain tensioner down
to loosen the chain and remove
the chain from the wheel sprocket
and motor sprocket. Push wheel
downward to remove.
2 Loosen the four (4) Phillips
screws and remove chain guard.
1 Loosen the two (2) 5 mm bolts on
the brake caliper and remove brake
caliper from disc brake.
Note the hardware sequence
(from outside toward the center).
Left Side (Brake)
16-7 17 mm Locknut
16-2 Flat Washer
Frame
16-6 Spacer
16-5 Caliper Bracket
16-4 Hat Spacer (Small)
-------------
Right Side (Throttle)
16-3 Hat Spacer (Large)
Frame
16-2 Flat Washer
16-1 Axle Bolt
16-1
16-2
16-2
16-5
16-3
16-4
16-6
16-7
WARNING: To avoid a
pinch or injury, keep fingers away
from moving sprockets and chain.
WARNING: Failing to
properly adjust and tighten the
nuts and bolts that affix the front
wheel can cause you to lose
control and fall.