User Manual

Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
2
CASTER BOARD PARTS AND COMPONENTS
CHECK BEFORE RIDING
CLEANING YOUR RIPSTIK
WHEELS AND BEARINGS
Product ID Locations:
1. Underneath platform
2. Box - side of UPC (not shown)
Concave Deck Platforms
Kick Nose
Torsion Bar
Deck Plates
(Select models only)
Kick Tail
360-Degree Inclined Casters
Urethane Wheels
NOTE: Your model may differ in appearance from the one depicted above.
Always inspect your caster board’s wheel bearings and other hardware to make sure they are tight before each use.
Wipe with a damp cloth to remove dirt and dust.
Do not use industrial cleaners or solvents as they may damage the surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may
damage or dissolve the plastic components.
Under normal circumstances and conditions, RipStik wheels and wheel bearings are maintenance free. Nonetheless, it is the responsibility of the owner or
guardian to periodically inspect the wheels for wear and tear, the axle for proper tightness, and the bearings for side-to-side play and loose parts.
When a wheel or wheel bearing develops play, this is an indication of excess wear and replacement is necessary. Replace immediately with only genuine
RipStik wheels. Worn wheels/bearings are considered normal wear-and-tear and are not covered by the RipStik Limited Warranty. Wheels other than
genuine RipStik wheels may not be compatible with your RipStik caster board. The use of anything other than genuine Razor replacement parts will void
your warranty.