Owner's manual

14-1 14-2
14-3
14-4
14-6
14-5
14-7
A.
A.
B.
1 Using a Phillips screwdriver remove the six (6)
screws and remove the deck plate.
(Note: There are two (2) sizes of screws,
A-Small, B-Large)
3 Disconnect the battery wire connector from the
control module and carefully remove the battery.
Note: If only replacing battery, install new battery
and reverse steps 1-3.
4 Disconnect the motor wire connector from the
control module.
8-1
8-2
8-2
8-3
6
REPAIR AND MAINTENANCE
Note: Rear wheel/motor
hardware sequence
Left Side
14-1 Phillips Screws (3)
14-2 Motor Housing
Right Side
14-3 Nut
14-4 Lock-Washer
Frame
14-5 Flat Washer
14-6 Lock-Washer
14-7 Locknut
Right Side
8-2 Spacer
Fork
8-1 Coupling Bolt
Left Side
8-2 Spacer
Fork
8-3 Bolt
1 Using two (2) 5 mm Allen wrenches, loosen the axle bolt.
Remove wheel and install replacement wheel.
(Note the sequence of the hardware)
q Front Tire Replacement
Tools Required: Two (2) 5 mm Allen Wrenches
Note: Front wheel
hardware sequence
q Rear Wheel/Hub Motor/Battery Replacement
Tools Required: Phillips Screwdriver and Two (2) 13 mm Wrenches
(Battery Replacement Steps 1-3)