Quick Start Guide

KICK SCOOTER

HEADSET BEARING

ADJUSTMENT INSTRUCTIONS

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

Figure 1 Figure 2

Step 1

Using a 5mm Allen Wrench, loosen the bolt on the

collar clamp and slide collar clamp up.

Loosen nut using an adjustable wrench.

Step 2

Figure 3 Figure 4

Using your hand, carefully turn the upper

headset crown counterclockwise 1/4” at a time

until handlebars turn smoothly. Test after each

1/4” turn.

Note: Make sure the handlebars are properly aligned with the front wheel before riding. If handlebars

are not aligned, loosen the bolt on the collar clamp and adjust the front wheel until it is perpendicular

with the handlebar. When properly aligned; retighten collar clamp bolt.

Retighten nut (Note: Be careful not to over tighten.

Overtightening can damage the ball bearings

inside the headset). Hold upper headset crown

in place when tightening the nut to prevent the

crown from moving. Slide collar clamp down

and re-tighten bolt.

Step 3 Step 4

Tools Required: (Not included)

A. 5mm Allen wrench

B. Adjustable wrench

upper

headset

crown

nut

PAGE 1
KICK SCOOTER HEADSET BEARING ADJUSTMENT INSTRUCTIONS Tools Required: (Not included) A. 5mm Allen wrench B. Adjustable wrench Step 1 Step 2 Using a 5mm Allen Wrench, loosen the bolt on the collar clamp and slide collar clamp up. Loosen nut using an adjustable wrench. nut Figure 1 Figure 2 Step 3 Step 4 Using your hand, carefully turn the upper headset crown counterclockwise 1/4” at a time until handlebars turn smoothly. Test after each 1/4” turn. Retighten nut (Note: Be careful not to over tighten.