Specifications

42 ST6000 Plus Autopilot Control Unit Owner’s Handbook
Note: If valid latitude data is available via SeaTalk or NMEA, it will be
used instead of this calibration value.
Wind Trim
This varies the response of the autopilot when in wind mode.
The settings available are as follows:
Range: 1 Normal setting
2 Faster response for wind shifts
Default: 1
Tack angle
This adjusts the heading change controlled by the Auto Tack feature
(+1 and +10 or –1 and –10)
The settings available are as follows:
Range: 40 to 125 degrees
Default: 100 degrees
AutoRelease
AutoRelease provides emergency manual override, should it be
necessary, to avoid an obstacle at the last moment. This option only
applies to cable operated sterndrive actuators – for all other systems this
option should be set to off.
Range: Off
On
Defaults: 0 for Displacement, Semi-displacement &
Planing
1 for Sterndrives
Response
This is the power-on response setting. The response level can be
changed during normal operation (see section 3.3) or via the Response
Data Page, if this is set for display (see section 2.6).
133_3c04.p65 14/06/99, 10:2442