Installation manual

10 SeaTalk Autopilot Hand-held Remote
Installing the SeaTalk socket
1. Apply the template onto the bulkhead as required.
2. Drill the 18 mm (
45
/
64
in) clearance hole and the two 2.5 mm
(
3
/
32
in) pilot holes.
3. Remove the template.
4. Cut and strip the SeaTalk cable (not supplied: see page 9).
5. Pass the cables through the bulkhead and wire to the socket,
making sure the wires are connected to the correct pins.
6. Use the two self-tapping screws to attach the socket to the
bulkhead.
7. Secure the cables at regular intervals using suitable cable ties.
Note: Should you require any spare parts, please refer to the spares
list on page 12.
D5691-1
81197_1.book Page 10 Wednesday, August 1, 2001 11:19 AM