Specifications

Chapter 7: Post Installation Procedures
61
Wind transducer interface
If the ST6000 Plus is connected to a wind instrument via its NMEA
data port or SeaTalk, then the link between the two instruments should
be checked as follows:
 Press standby and auto together.
The ST6000 Plus should display the Vane mode screen, with the
locked wind angle and locked heading as shown.
Alternatively, if the wind data is not received , the ST6000 Plus will
display a NO DATA error message.
SeaTalk interface
If the ST6000 Plus has been linked to other SeaTalk instruments via
SeaTalk, the link can be checked as follows:
1. Press standby.
2. Select display illumination level 3 on any other SeaTalk instrument
or autopilot control unit.
The ST6000 Plus should immediately respond by switching on its
display illumination.
If the illumination does not switch on then a cabling fault exists in the
SeaTalk cabling between the ST6000 Plus control head and the
instruments/control unit.