Specifications

38 ST6000 Plus Autopilot Control Unit Owner,s Handbook
The default pages are:
Data Page Default Setting Sequence Number
1 XTE Cross Track Error 12
2 BTW Bearing to Waypoint 14
3 DTW Distance to Waypoint 13
4 NOT USED 19
5 NOT USED 19
6 NOT USED 19
7 NOT USED 19
 For each setup page, scroll forwards or backwards using the +1 or -1
keys, until the required page title is displayed.
Notes: If you set a page to NOT USED, it is omitted from the display
cycle during normal operation. For example, with the default page
settings only three pages are displayed in the sequence.
There are 3 depth pages and 2 water temperature pages. Data is
displayed in the units defined by the selected page.
 Press disp to move on to the next Data Page selection screen, and
repeat the selection procedure.
Note: If a man overboard (MOB) message is received by the autopilot,
the BTW and DTW pages will display the bearing and distance to the
MOB location, so it is good practice to retain these pages for display.
5.2 Dealer setup: Type 100/300 Course Computer
This section applies if you have installed the ST6000 Plus as the control
unit for a Type 100/300 Course Computer. If you are using the ST6000
Plus as a repeater for another autopilot system, refer to the Dealer Setup
instructions in the handbook for the main control unit.
Dealer Setup is used to customise the autopilot to your boat. However,
once the Pilot Type is set, the factory defaults will provide safe
performance for initial sea trials, and fine tuning is not normally
required. The flow chart below shows you how to enter Dealer Setup,
scroll through the setup displays, adjust the values and exit.