Installation Manual Part 7

FCC ill: CDG-ARTU EXHIBIT C
MAGNASTAR C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
The first screen when starting the MMTI software is the MMT Start-up menu. To begin the conDnanded
mode operation, make the appropriate selection from the MMTI Start-up menu as shown in figure 9.3.2. If
the ARTU has been powered prior to starting the MMTI software. the user will then proceed to the MMT
Main menu. Figure 9.3.3 shows the MMT Main menu screen. If power is applied to the ARTU after the
MMT software has started running, the user will then proceed to the MMT Boot Menu when the
CODm1anded mode of operation is selected. Power must have been feDX)ved from the ARTU for greater
than ten seconds in order to proceed to the Boot menu from the Start-up menu.
A breakdown of each oftbe four sections with a description of each sub-~u is provided in the following
sections.
+ V'.OA ~ -.4io "8P0D8e +
: ~ Propzoietaryo 8of~ :
: ,..tar 87 v_.iOG '.0& :
: IU'rALL8a VDBI~ :
: (C) Copyright 1'" aQtlaeOD .,..t- C-. :
I - er (C) CGpJ'Z'ight 1"'-1'" PIaar ~ 8of~. X-. - 81,-'503 :
: > Wt~h aerial Cable < :
+ +
+ r ~ +
: C-3000 -.r ~ 0ftZ~ - :
: I
: 1 - 8t.an -.r - C-.a4 _. :
I 3 - 8t.&&'t. -.r - I_t.a11at.~ :
I I
I ,
: 881ect. -.r .t.aft-~ ~ioa C 1 - 3. 0 too ~it. -.r) I - I
Figure 9.3.2. The MMT Start-Up Menu Screen
+ V'.OA ~ 884io " +
, ,
, ,
: ~-ap 8taC... 80378 Kicroproc...or OK. 8aAK OK. :
: Aa'fC 0048 rile Aa'fCC'08.8D Vezo 0.0 DeC. 0'/08/00 1,.25 88M 1 cac.f.CD:
: ~ code rile ~'0A.8D Vezo 0.0 DeC. 03/27/00 12.13 88M 2 cac.12'8:
: arr ood8 rile KarrC'OA.8D Vezo 0.0 DeC. 05/18/" 18.03 88M 1 C8Cs20ee:
: 8ooC ood8 ril. ML-.cJ1C.8D Var 0.0 DeC8 0'/2'1'8 1,.27 88M 1 C8Cs'" :
: 884io -'~ i. - _ciag.
+ +
~ .~ : C-2000 ~ DX8 - :
, ,
, .
: 1 - ~ 88dio CODfigazo.ci- - :
: 2 - ~ 884io XA8C&11aCi-"_c - :
:J-~8ooC- :
: , - _0 88dio *iAt:--. aperati-. -- :
: :
: 8DCezo Kai. - C-- (1 - '. 0 to q,.it t.Joe ~). - I
I I
Figure 9.3.3 The MMT Main Menu Screen.
9-21
RevB