Installation Manual Part 5

EXHIBrrc
C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
FCC 10: CDG-ARTU
MAGNASTAR
supported. Follow the steps below to program a CDBR-2 port configured as a PC station to treat an incoming ground to air
call as either a Voice, FAX, or TDD call.
Select
1
--~
Begin a
Remote
Program
session
as
shC*n
on
prior
page.
Select
+
~
station
cockpit >1
«ibin ~
Enter
pas.code
+
-->
nea..-
Enter
Your
Passc~
Choice.
will be
shaded .
Uplink
Voice ->3
.. -->.
TDD --->!
OK >+
Clear -->*
Go Back >t
7.2 AIRCRAFT CONFIGURATION SHEET
The aircraft configuration sheets are used to provide the customer with a permanent record of the progrannning set-up of the
C-2000 system in the aircraft. It should be filled out prior to aircraft delivery. Because the programming of the system is
stored in the ARTU memory, if the ARTU needs to be replaced, the system would have to be reprogrammed. The use of the
aircraft configuration sheets can be used to help the person programming the system recall the exact set-up.
7-26
RevB