Installation Manual Part 4

EXHIBIT C
LEPHONESYSTEM
FCC 10: CDG-ARTU
MAGNASTAR
C-2000 DIGITAL AIRBORNE T
7.1.2.6.1 Station Setup
A MagnaStar digital handset when connected to the LAN is considered a station. It is possible to configure a handset for
different types of operation or station types. A Cabin station is the system default mode and is considered the normal
condition. A Cockpit station is the same as a Cabin station except for operation when the system Billing mode is configured
for credit card. If the system Billing mode is set for credit card use, then any handset configured as a Cockpit station will bill
the aircraft account and not require the use of a credit card. There is no limit on the number of handsets that can be
configured as Cockpit stations.
A digital handset can also be configured as a FAX, Modem, TDD or PC station. These station types configure the use of the
RJ-II jack on the handset. Configuring a handset as a Fax, Modem or TDD station has the following effect; when using the
RJ-II jack, the phone number can be directly dialed from the connected device mther than using the handset keypad Also,
because the device type or call type is identified, only the ten digit number needs to be dial (for domestic calls). When
configured as a PC station, any dialing activity on the RJ-II jack must be preceded by a "3" or "4" prefix to identify the type
of opemtion; Fax (3) or Modem (4). Both functions can be used as long as the prefix identifies the type of opemtion. The
handset does not have to be taken out of the bezel (or taken otThook) to be use when a handset has been programmed as a
Fax, Modem, TDD or PC station. Only one digital handset in a system can be configured as a Fax, Modem, TDD or PC
station.
Select the appropriate number for
the type of operation required.
Stati
Cock
Q.x
FAX
Mode
TDD
PC-
The current configuration mode will
be highlighted.
Select 1
to change
the
Station
Setup.
-->
Go Back >*
7.1.2.6.2 Select Aero-H or Aero-I SATCOM Service
A user may select the Aero-H SA TCOM service, instead of Aero-l SA TCOM service for FAX calls. If both services are
available (Aero-H+), SDUs (Satellite Data Units) manufactured by Collins and Honeywell default to Aero-l which supports
2400bps FAX calls. Aero-H supports 4800bps FAX calls. The higher rate SA TCOM FAX mode may be enabled but should
be done only for Aero-H+ SA TCOM installations otherwise the SDU will reject the FAX call setup.
us/
Cana~
Mexico
.~
Mexico
~I
>2
Station -
Setup ->1
To Disable
Ringer >2
Dialing
Plan -->3
Link --->4
Select
!elect
Select
4
-->
To
Ae:(
Sa
Di~
Pr"
To
Ael
Sat
Dir:
Prf'
More --->+
Go Back >1
More --->+
Go Back >t
Go Back >t
RevB
7-15
on
~!,~~l
~[c+"'"'>2
>3
III -->4
>5
>6
Disable
:-o-I/H+
~com
tling
}fix->3
an
:0-
:ca
lli
Ifi
able
I/H+
m
ng
x->3