Installation Manual Part 4

EXHIBITC
C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
FCC ill: CDG-ARTU
MAGNASTAR
7.1.2.5.5 CaD Waiting
The following screen progressions show bow to enable or disable the call waiting feature. Call waiting will alert the user of
an additional incoming call regardless of its origin (inplane or ground initiated) while engaged in a telephone call.
Inplane>1
Aircall >2
Satcom ->3
The call Waiting feature may be toggled to
display enable or disabled by entering a
keypress of 4.
Select
4
-->
Warning: The Enable or Disable shown on the
screen describe$ the $tate the system will be
placed when a 4 is pressed. The example
screen indicates that call waiting is
disabled.
To Enable
Call
Waiting >4
Go Back >#
7.1.2.5.6 Speed Dial
The following screen progressions show how to enter speed dial numbers. The following items are to be entered. The three
digit speed dial number (*510 through *549), a phone number and a 10 character label. The label is an optional entry.
--
Enter
dialing
sequence
Enter
the type
of service
(1= voice,
3= Fax,
4= Modem)
followed
by the
number to
be dialed.
Then enter
+ for OK.
-->
Sel-
*
Spe-
Dia
Set
Enter 3
digit
speed dial
number
510-549
Enter the three
digit speed dial
number in the
510-549 range.
Then enter + for
OK.
-->
Svc+Number
1+8882467
827
510
OK >+
Clear -->.
Main --->I
OK >+
Clear -->*
Go Back >t
Select
5 to
delete
a
number
You maY--
enter a 10
character
label.
You
ent'
cha
lab
Select +
to save
the speed
dial entry
Enter a 10
character label
for the entered
speed dial
number.
Star Line
"
CUrsor ->*
OK/Next >+
OK/Main >t
Help --->0
CUrsor ->*
OK/Next >+
OK/Main >1
Help --->0
Select 0 to
view the help
screen -->
7.1.2.5.7 AIU Configuration - SATCOM
The fo)]owjng screen progressions show the options available for configuring the AlU when used wjth an analog SATCOM
system. The AlU SA TCOM features include two different impedance configurations and two possible interface modes of
operation. The two different impedance configurations are High Impedance (WH-IO type) and Low impedance (600 ohm).
The two different modes of operation are Handset and PBX. The Handset mode provides no feedback to the user on the LCD
display and operates strictly as a handset would. In the PBX mode the handset provides the user with feedback information
on the handset LCD display providing the dialed number and ca)] progress information. This mode is only valid for those
SA TCOM systems which support handset PBX functions.
RevS
7-12
ect
for
ed
1
-up
>
may
er a 10
racter
el.