Installation Manual Part 2

FCC ID: CDG-ARTU
MAGNASTAR
EXHIBITC
C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
6.3.4 MMT OPERATION
This step selects the installation tutorial mode of operation for the MMT from the from the start-up
options menu after the MMT software has started execution.
When the MMT software has started execution, the computer screen will display information in
two windows as shown below in Figure 6-1. The upper window is the MMT Radio Responses
window which is used to display feedback (response) information from the ARTU. The installer
will view the information in this window to verify proper performance of the C-2000 system during
the installation. The lower window is the MMT Menu Prompt window which provides the installer
with command options and provides a short summary of tasks for the installer to perform.
Verify that the MMT cable connects the computer to the ARTU.
With the MMT computer screen display shown in Figure 6-1, type "2" and then
press "ENTER" to select the MMT Installation option.
Note: The MMT - Command Menus option is reserved for troubleshooting activities.
+ V'.OA HNT Radio Re8PQaae +
: Proprietary Soft~e :
: MagDaStar HNT Version'. OA :
: IKS'1'ALLD VDS%c. :
: (C) Copyright 1.99' Raytheon Syst- C~ :
: ~ DOS-8xt8Dd8r (C) Copyright 1.986-1.99' Pbar Lap Soft~., %Dc. .. D81.-9S03 :
: > Attach Seria1. Cable < :
I I
I I
+ +
+ HNT ~u ~t +
I C-2000 ~ STARTUP OP'1'%c. .au :
I I
I I
: 1. - Start." - C~ NeDus ( UTO or CDB%) :
: 2 - Start." - %D8tallatiOD I
: I
: Select .-'!' .tart-up option (1. - 2, Q to QUit ~): - :
. f
I
I .
I J
I t
I .
+ ~~~~
Figure 6-1. MMT Installer display screen #1
6-3
RevB