Installation Manual Part 2

FCC ill: CDG-ARTU
MAGNASTAR
EXHIBITC
C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
6.3 C-2000 INSTAllATION CHECKOUT with MMT
The installer must know the following information before starting the MMT Installation:
a) The number of CDBRs and AIU's that are used in the installation.
b) The number of Handsets that are to be used in the installation.
c) If the location at which the installation is being performed will support
communications with a GTE AIRFONE GenStarTM System Ground Station.
6.3.1 MMT COMPUTER SET-UP
See Section 8 for computer set-up.
6.3.2 MMT CABLE CONNECTION
The MMT computer is to be connected to the ARTU using the MMT cable. (The MMT interface is a RS-
232C serial interface.)
Connect the 9 pin D type connector of the MMT cable to the "COM .. port of the MMT
computer.
Remove the protective cap from the MMT connector of the ARTU.
Connect the circular connector of the MMT cable to the MMT connector on the ARTU.
6.3.3 EXECUTING MMT SOFTWARE
The following commands are to be used to start execution of the MMT application software in the
computer.
If required. power up the computer and wait for the computer to complete the boot
process. It is assumed that the computer will boot up to the "C" drive with and
have no other applications running.
Change the directory to the MTU directory, type: "CD MTU and press "ENTER",
C:> cd mtu
To start execution of the MMT software from the MTU directory, type: "MMTI" and
press "ENTER".
C:\MTU> mmti
Note: when the computer is executing the MMT software. the computer will be
referenced as the "MMr .
RevB
6-2