Installation Manual Part 2

FCC ID: CDG-ARTU
MAGNASTAR
EXHIB IT C
C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
6.3.17 C-2000 INSTALLATION CONCLUSION
The C-2000 Installation testing with the GTE Airfone GenStarTM Ground Station is finished at this
point. Any further installation steps may not require MMT connection to the ARTU. If this is new
installation, the next step is Handset Configuration (Section 7). This step concludes the MMT
Installation by having the installer enter a command to quit the MMT Installation mode.
Quitting the MMT
To quit the MMT at this point. continue with the following steps:
The MMT display screen will be similar to that shown in Figure 6-21.
Type "Q" to quit the MMT C-2000 Installation.
Note: Turn "off'the MMT computer to conserve battery power.
Disconnect the MMT cable from the ARTU.
Reconnect the MMT dust cover to the MMT connector.
+ Vt.OA -.T Radio R..POD +
I I
I I
I I
I I
I ,
I ,
I I
I I
I I
I I
+ +
+ VlA ~ Tutorial +
: D8~]" 8'r orB C-2000 ~~ :
I I
I I
: ~. CODclude. the 8'r C-2000 XD8ta11atiOD. :
I I
I I
: To QDit the MNT, pr... '0' at thi. t!8e. :
I I
I I
: To r.-_cut. the 8'r Tutorial, pre.. 'c' at thi. t~. :
I I
I I
I I
I I
I I
I I
I I
I I
: (C)ODtiau8, (7)roQbl..boot, (a)epeat, (Q).t~1 - :
+ +
Figure 6-21. MMT Installer display screen #21
Re-executina the MMT
The MMT tutorial may be also be re-executed at this point. If the MMT is to be re-executed,
power to the ARTU must be removed for greater than ten seconds.
The MMT display screen will be similar to that shown in Figure 6.21
Remove power to the ARTU for greater than 20 seconds.
Type "C" to re-execute the MMT C-2000 Installation.
PROGRAMMING THE MAGNAST AR SYSTEM
6-22
RevS