Installation Manual Part 2

FCC ill: CDG-ARTU
MAGNASTAR
EXHIBIT C
C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
Figure 5-2 MagnaStar C-2000 System
5.1.7
FAX/MODEM CABLE
a) Prior to FAX/modem cable installation, perform a visual inspection on the
FAX/modem, the Handset and the RJ-11 cable for damaged connectors or
mounting hardware.
b) Remove the Handset from the bezel and connect the RJ-11 cable to the FAX/modem
machine and the Handset.
c) When connecting the FAX/modem to the Handset, insure that the RJ-11 cable
connectors are fully engaged.
d) Place the Handset back in the bezel. Insure that the RJ-11 cable is not pinched or
damaged when the Handset is placed in the bezel.
5.2
AIU SOFTWARE COMPATIBILITY
The operation of the AIU requires MAGNAST AR software Version 2.28 or later.
After all the MagnaStar system components have been completely installed with the AIU
connected to the HF or intercom equipment. apply power to the system and verify the
software version of the ARTU. This is done by use of the Set-up and Maintenance
screen on the handset. From the main menu press '9' to select Setup, press '3' to select
Info from the Setup Menu, and finally press '+' from the Info menu. The ARTC software
version will be displayed, verify that the version is 2.28 or later.
If the software version is not 2.28 or later you will need to download the current version of
ARTC software. Contact your dealer or call Teledyne Controls (1-888-246-STAR) for a
copy of the current software and technical assistance.
5-4
RevB