Installation Manual Part 2

FCC 10: CDG-ARTU
MAGNASTAR
EXHIBIT C
C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
The installer should observe two indications that Power-up BIT testing has
successfully been completed:
First, the MMT Radio Responses window will display "C-2000 Power-up BIT
Passed", as shown in Figure 6-7.
Second, the installer is to observe the FAULT indicator. The FAULT
indicator should be "Off" (not illuminated).
After successful completion of Power-up BIT. type .'C" to continue the MMT
installation.
If the ARTU does not successfully pass Power-up BIT, proceed to
Troubleshooting Procedures (Section 9).
+ V&.OA HMT Radio Re8PQDa +
: .X~ 78.~ POWER-UP ax~ pa..ed. raul~: 00 00 00 00 :
. I
. I
, I
, I
: C-2000 ~-UP arr pa..ed :
: S.l8C~ 0 f~ C_auded .X'1' Meuu to vi- ax'1' a..ult. :
, ,
, ,
: Radio .of~ _tiDg iD UDloeked ~liDe .tat.. :
+ +
+ ~.-'!' '1'utorial +
: mSlAlOS .-r D.-aB'1'U C-2000 ms'1'ALLA.'1'X~ :
""-O=---=~-~ I
, : I
: V.rity ~t ~-up a.ilt-%D 78.t (B%'!') CO8pl.t.. 8Ucc...fu1~y. :
I I
I I
: UPBC'rBD USUL'1'S: :
: Fault iDdicator OD froDt of AR'1'U i. axtiDgui.hed (off). :
: S-zy ~r-up an r..ult _..ag. i. diaplay.a iD ~ ...P0D8'. wiD4ow: :
: .C-2000 POM8R-UP Brr P...ed. :
I ,
I ,
:AC'1':EC8S: :
: 0 Mait for po.er-up a%'1' to ca8pl.t. (aay ~. up to fiV8 aiDQt..). :
: 0 Oba.rY8 fault iD4icator light i. axtiDguiahed (off). :
: 0 Oh..rY8 ~ po.er-up err r.nlt _..age iDdicat.. paa~. :
: (C)ODtiDa., ('1')roahl.8hoot, (Q)uitz - :
+ +
Figure 6-7. MMT Installer display screen #7.
6-9 RevB