Installation Manual Part 2

FCC ill: CDG-ARTU
MAGNASTAR
EXHIBIT C
C-2000 DIGITAL AIRBORNE TELEPHONE SYSTEM
6.3.8 START ARTU OPERATIONAL SOFTWARE
In the following steps. the installer will start the execution of the ARTU operational software and
verify successful completion of Power-up Built-ln- Test (BIT). Operation of the Power-up BIT is
verified by observing the status of the ARTU FAULT indicator and viewing the results in the MMT
Radio Responses window.
Type "C" to start ARTU operational software. Once the command is given to start the
operational software. Power-up BIT will begin execution.
Note: The time to complete Power-up BIT may vary from one to five minutes depending on the
amount of time the ARTU frequency reference requires to warm-up.
Observe that the MMT display screen is similar to that shown in Figure 6-5.
+ V4.0A -.T Radio aespouaes +
I I
I I
:Pow8r-up Btatusz 80376 Microprocessor OK, BRAN OK. :
: AaTC code rile AaTCC'Ix.RBX Ver 1.1 Date .1/.'1'1 Ilzll BaDk I CRCzI'" :
: DBP code rile HDSPC"x.RBX Ver 1.1 Date "1"/'1 IIz" BaDk I CRcz.'" :
: BZT code rile HBZTCI.x.BBX Ver 1.1 Date "1"/" "zI' BaDk, CRcz"" :
: Boot code rile H_BTC"X.BBX Ver 1.1 Date '.1"1" "Z" ~. CRcz"" :
: Radio software is Dot executing :
, ,
I ,
+ +
+ ~ -.T Tutorial +
: mBU.lO. 8'1' KAC8AS'1'U ZRS'l'ALLA'1'I<8 t
: 08J8C'fIV8: I
: V.rify that pGW8r-ap BQilt-ID T..t (BI'1') begiua executioa. I
I I
I I
: DPBCftD auUL'l'S: :
: hult iDdicator CD front of AR'l'O i. ill1miDated (red). :
: Power-up 81'1' re.ult _..ag.. are 4iaplayed in -.T Radio a.8PQD8.. window. :
I I
I I
:AC'rZ~s I
I 0 Pr... 'C'CDtiDDe to begiD pGW8r-ap BIT ..ecutiCD. I
t I
I I
I I
I I
: (C)~tinu., (T)roabl.8hoot, (a)~t, (Q)1Iits - ~
+ +
Figure 6-5. MMT Installer display screen #5.
6--7
RevB