User's Manual

Table Of Contents
MM102558V1 R1A
Figure 6-14: RF Power Amplifier
6.2.4 RF Antenna Switch Assembly
An RF Antenna Switch assembly, shown in Figure 6-15 is available for
conventional MASTR III ADC stations operating in the simplex or half-
duplex base station mode.
The Antenna Switch is available with or without mounting hardware and
cabling. Mounting hardware options are available for mounting the
Antenna Switch either directly to the RF PA assembly or as a 19” rail
mounted device.
Figure 6-15: Antenna
Switch
6.2.5 Cabinet Enclosures and Open Rack Assembly
MASTR III ADC station equipment is typically installed in a steel cabinet or rack, however may be
ordered without a cabinet or rack. Cabinet enclosures include front and rear doors for full station access.
Also available is an indoor open rack and a weatherproof outdoor cabinet.
The following list defines the available cabinet sizes, styles, and number of MASTR III ADC stations that
can be installed into each type of cabinet or rack, dependent upon the hardware options installed in
conjunction with each station:
37" Indoor Cabinet (1 station per cabinet)
45” Weatherproof Outdoor Cabinet (1 station per cabinet)
69” Indoor Cabinet (1-4 stations per cabinet)
83" Cabinet (1-5 stations per cabinet)
86" Open Rack (1-5 stations per rack)
49