User's Manual

Table Of Contents
MM102558V1 R1A
5.6 PROGRAMMABLE FEATURES FOR CONVENTIONAL STATIONS
Most MASTR III ADC station features may be accessed using a PC compatible computer and the latest
version TQS3353 Programming Software. Station configurations discussed in Section
5 require features
to be properly set via programming software.
Most MASTR III ADC feature programming is stored in the Station’s System Module. This section of
the manual is written to describe the programmable features of the MASTR III ADC station and how they
apply to Conventional and P25 Conventional base and repeater station operation.
When programming a MASTR III ADC station, it is advisable to read and save
(archive) the personality from the station before attempting to program features.
Always save (archive) any programming changes to a different filename to preserve
the original personality in case the changes you have made are unsuccessful.
Programmable features discussed in this section include the following:
Conventional Stations (Setup)
o No Remote
o DC Remote
o Tone Remote
o Type 90
o DTMF
Main Station Data (New)
o Transmit and Receive Frequency
o Channel Guard
o TX Pot
o CG Pot
o RF Simplex and Rpt
o PA Power
Push-to-Talk Options (PTTs)
o Repeat PTT
o Remote PTT
o Local PTT
o External PTT
o Morse Code ID PTT
Potentiometer Settings (Pots)
More Features (Additional)
o Carrier Control Timer
o Squelch Tail Elimination
o Drop Out Delay Timer
Control Shelf (Options)
o Morse Code ID
o Battery Alarm
o Logic Standby
o Intercom
o Bandwidth
o Receiver Channel Scan
Station Remote Control
o Two-Wire/Four Wire Operation
o DC Remote Control
o Tone Remote Control
o Auxiliary Control Relays
o Squelch Operated Relay
o Channel Guard Monitor
o System Module - DSP
33