User's Manual

MM102558V1 R1A
Audio (receiver to line):
Audio Amplifier Input Impedance: 10K ohms
Input Level: 1 Vrms (for 5 kHz Deviation)
Output Impedance to Line: 600 ohms (2-wire or 4-wire)
Output Level to Line (1 kHz ref.): +7 dBm (adjustable)
Tone (1 kHz ref.): +7 dBm (Reference 7 dBm)
Frequency Response: +1 and –3 dB @ 300 to 3000 Hz
Hum and Noise, Noise Squelch: -55 dBm (Reference 7 dBm)
Tone Squelch: -30 dBm (Reference 7 dBm)
DC Remote Control Currents: -2.5 mA, ±6.0 mA, ±11.0 mA
Line Loop Resistance (maximum): 11K ohms (includes 3K ohm termination)
3.5 TRANSMITTER
VHF
ANALOG
VHF P25
DIGITAL
UHF
ANALOG
UHF P25
DIGITAL
800 MHz
ANALOG
800 MHz P25
DIGITAL
Frequency Range (MHz) 136 - 174 136 - 174
380 - 512 380 - 512
851 – 870 851 – 870
Rated Power Output (W)
1
10 - 110 10 - 110
10-100 10-100
10 - 100 10 - 100
RF Output Impedance (Ω)
50 50
50 50
50 50
Conducted Spurious and
Harmonic Emission
-36 dBm -70 dBc
-36 dBm -70 dBc
-36 dBm -70 dBc
Frequency Stability (ppm)
2
±1.0 ±1.0
±1.0 ±0.5
external
freq. std.
±1.0 ±0.15
external freq.
std.
Modulation Deviation (kHz)
Wideband 0 to ±5 N/A
0 to ±5.0
N/A
0 to ±5.0
N/A
Narrowband 0 to ±2.5 2.83 kHz
nominal per
TIA 102
CAAB
0 to ±2.5
±
2.83 nominal
per TIA 102
CAAB
N/A 2.83 kHz
nominal per
TIA 102
(CAAB)
FM Noise (dB) -55 N/A
-55 N/A
-55 N/A
1
Rated power output is measured at the transmitter power amplifier output connector per FCC Certification information.
Any customer-required optional items such as power measuring devices and/or duplexers will introduce loss between the
transmitter output connector and the station cabinet output connector. This loss will reduce the available power at the station
connector.
2
Frequency stability is relative to the stability of the Reference Oscillator. Unless otherwise specified, the value shown in
this table is relative to the internal Reference Oscillator signal which is provided by the corresponding Receiver Synthesizer
Module.
15