User's Manual

P25net Channel Controller Operations Manual
3-21
3.11.2 Default Radio Settings Loaded
After loading a notification of the action will be displayed (see Figure 3-22 Default Settings
Applied Screen ).
Figure 3-22 Default Settings Applied Screen
3.12 Fallback Mode
The Fallback Mode can be enabled to provide conventional P25 repeater operation in the event
that the BSC reboots or experiences a problem communicating with the P25net CC. Trunking
will not be possible until BSC operation is restored.
In addition, it is possible to operate the P25net CC as a conventional P25 repeater (sometimes
referred to as a “Dumb Repeater”) without connecting a BSC; this requires enabling the
Fallback Mode.
To enable the Fallback Mode, enter PCCT and select Configure>Fallback Param (see Figure
3-23 Fallback Mode Enable Screen ) and place a check in the box.