User's Manual
Table Of Contents
- 0 General
- 1 BASIS SETTINGS TO USE THIS RADAR
- 2 OPERATING INSTRUCTION
- 2.1 Radar Operation
- 2.2 Set to Operation
- 2.3 Display Organization and Submenu Structure
- 2.3.1 Sensitivity Controls
- 2.3.1.1 Gain and Clutter Processing
- 2.3.1.2 Tune
- 2.3.1.3 Gain
- 2.3.1.4 Sea
- 2.3.1.5 Rain Rate
- 2.3.1.6 Automatic Clutter Reduction
- 2.3.1.7 Filtering Rain Clouds FTC
- 2.3.1.8 Search and Rescue Transponder SART ON/OFF
- 2.3.1.9 Pulse Width Selection (only available in Master mode)
- 2.3.1.10 Interference Selection IR ON/OFF
- 2.3.1.11 Echo Expansion EXP. ON/OFF
- 2.3.2 Radar Video Displays
- 2.3.3 Radar Video Settings
- 2.3.4 Navigational Elements MAP, PIL, EBL and VRM
- 2.3.5 Cursor Information
- 2.3.6 Cursor in Park Position
- 2.3.7 Information Panel
- 2.3.1 Sensitivity Controls
- 2.4 Select Target Information TGT INFO
- 2.5 Target Menu
- 2.6 Zone Management
- 2.7 Function Menu
- 2.7.1 Select the Backlight Menu Brightness Control and Color Palette
- 2.7.2 Select T-SCE (ON/OFF)
- 2.7.3 Select Route (Option)
- 2.7.4 Select Zoom Menu
- 2.7.5 Select Sector Blanking (ON/OFF)
- 2.7.6 System Clear
- 2.7.7 Performance Monitor (PMU)
- 2.7.8 Magnetron Current
- 2.7.9 Test Alert
- 2.7.10 Senc Menu
- 2.7.11 Chart Info
- 2.8 Chart Radar Function
- 2.9 Select ARPA Trial Manoeuvre
- 2.10 Sea Scout (Option)
- 2.11 Alarm and Warning messages and handling
- 2.12 Working Around the Radar Antenna
- 3 Theory of Operation
- 4 Index
Synapsis Radar
with Nautoscan NX Pedestal
Operator Manual
Edition July 2015
2-225
4265.DOC020102
ALARM MESSAGE
a) Problem Description
b) Corrective Action
NOT TRANSMITTING
a) The Radar transceiver receives transmit
commands but is not transmitting
because of an internal error (e.g.
electrical failure).
b) Refer to the maintenance section for
troubleshooting and repair.
Call Service.
NO TRIGGER
a) Radar probably not transmitted.
b) Start the Radar System again.
Refer to the maintenance section for
troubleshooting and repair.
Call Service.
PMU RX ERROR
a) The performance monitor detected
reduced sensitivity of the Radar receiver.
b) Refer to the maintenance section for
troubleshooting and repair (Tune the
receiver).
Call Service.
RADAR CONTROL
CALLBACK
(MK2 Transceiver)
a) External alarm from Transceiver no
connection between computer and
transceiver.
b) Call Service.
RDP FAILURE
(RID FAILURE ALARM)
a) Internal software process is disturbed.
b) Start the Radar System again.
Refer to the maintenance section for
troubleshooting and repair.
Call Service.