User's Manual
Table Of Contents
- 0 General
- 1 BASIS SETTINGS TO USE THIS RADAR
- 2 OPERATING INSTRUCTION
- 2.1 Radar Operation
- 2.2 Set to Operation
- 2.3 Display Organization and Submenu Structure
- 2.3.1 Sensitivity Controls
- 2.3.1.1 Gain and Clutter Processing
- 2.3.1.2 Tune
- 2.3.1.3 Gain
- 2.3.1.4 Sea
- 2.3.1.5 Rain Rate
- 2.3.1.6 Automatic Clutter Reduction
- 2.3.1.7 Filtering Rain Clouds FTC
- 2.3.1.8 Search and Rescue Transponder SART ON/OFF
- 2.3.1.9 Pulse Width Selection (only available in Master mode)
- 2.3.1.10 Interference Selection IR ON/OFF
- 2.3.1.11 Echo Expansion EXP. ON/OFF
- 2.3.2 Radar Video Displays
- 2.3.3 Radar Video Settings
- 2.3.4 Navigational Elements MAP, PIL, EBL and VRM
- 2.3.5 Cursor Information
- 2.3.6 Cursor in Park Position
- 2.3.7 Information Panel
- 2.3.1 Sensitivity Controls
- 2.4 Select Target Information TGT INFO
- 2.5 Target Menu
- 2.6 Zone Management
- 2.7 Function Menu
- 2.7.1 Select the Backlight Menu Brightness Control and Color Palette
- 2.7.2 Select T-SCE (ON/OFF)
- 2.7.3 Select Route (Option)
- 2.7.4 Select Zoom Menu
- 2.7.5 Select Sector Blanking (ON/OFF)
- 2.7.6 System Clear
- 2.7.7 Performance Monitor (PMU)
- 2.7.8 Magnetron Current
- 2.7.9 Test Alert
- 2.7.10 Senc Menu
- 2.7.11 Chart Info
- 2.8 Chart Radar Function
- 2.9 Select ARPA Trial Manoeuvre
- 2.10 Sea Scout (Option)
- 2.11 Alarm and Warning messages and handling
- 2.12 Working Around the Radar Antenna
- 3 Theory of Operation
- 4 Index
Synapsis Radar
with Nautoscan NX Pedestal
Operator Manual
4265.DOC020102
2-166
Edition July 2015
2.6 Zone Management
Automatic plotting means that the Radar can acquire and track maximal 40
targets automatically.
The possible tracking zone of all acquired targets can be 0,25 to 20 NM.
The operator can define acquisition zones.
As soon as a target enters such a zone, it is plotted and tracked by the Radar.
If a sleeping AIS target enters an acquisition zone, the target is activated.
Despite all the advantages of automatic target acquisition, it
may be found:
Certain targets cannot be acquired due to the current
weather conditions.
Targets cannot be acquired due to the set acquisition zone.
Targets cannot be acquired due to their size and material.
The target information is displayed when striking the TGT INFO soft key.
ARPA ZONES in a INS System.
An ARPA ZONE created on a MFC console displays in continuous line and
yellow color (active ARPA ZONE). Targets arriving this ARPA ZONE will be
acquired on this MFC console.
The same ARPA ZONE displays on the other MFC in yellow color and dashed
lines (passive ARPA ZONE). Targets arriving this ARPA ZONE will not be
acquired (chapter 2.6.4).