User's Manual

Synapsis Radar
with Nautoscan NX Pedestal
Operator Manual
Edition July 2015
2-81
4265.DOC020102
Operator controls
Task
Creating a NAV LINE (ROUTE LINE) overlay.
Step 1 Select the NAV LINE soft button (e.g. solid lines).
Step 2 Position the cursor and press the left trackball
button for the start drawing of the 1st line. Position the
cursor at the next point and press the left trackball button
again. Repeat this action until the complete NAV LINE is
shown on the PPI.
Pressing the right trackball button completes drawing of
the NAV LINE.
Operator controls
Task
Editing a NAV LINE (ROUTE LINE) overlay.
Editing a NAV LINE allows you to change existing
navigation lines. Either individual polygon points or the
entire MAP can be repositioned.
Step 1 Select the SELECT soft button for NAV LINE.
Step 2 Select NAV LINE overlay using trackball and press
right trackball button. The NAV LINE display changes and
all connecting points are shown. The EDIT function is
activated.
Step 3 Select the EDIT MARKER soft button The EDIT
NAV LINE dialog window appears in the function display.
Step 4 In this status, there are three editing options
possible:
A Change the bearing of the NAV LINE by moving
one of the points. Select the point of interest using the
trackball and press the right trackball button. The current
cursor position is shown in the EDIT NAV LINE display.
Determine marker position and drop by pressing the left
trackball button.
B Move NAV LINE or entire MAP in Radar video.
Position the cursor on a line in the MAP and press the