User manual

Installation
MI 17

Figure6:ConnectingofCablestotheElectronicBox
5. Putthefollowingonthecable(asshowninthefigure
above):
the cap (1), the plastic compression fitting (2), the rubber
washer(3)andoneofthemetalwashers(4).
6. Spread the cable shield (5) and then slip the second metal
washer(4)onthecable.Notethattheshieldmustmakegood
contacttobothmetalwashers.
7. Slip
 the wires (6) into the electronic box far enough to
connecttothepowerandoutputterminals.
8. Screw the cap (1) into the electronics box. Tighten snuggly.
Donotovertighten.
9. Connectthewires(6)tothe powerandoutputterminals on
theprintedcircuitboard.
Cable that has to be
installed b
y
the user
Output signal and
p
ower connector bloc
k
Preinstalled cable
to sensor head