User manual

Operation
MarathonSeriesFA/FR 29

Figure26:AveragingExample
TosetandactivateAveraging,dothefollowing:
1. PresstheModebuttonuntiltheAVGLEDislit.
2. Press thec button to both set and activate. The display reads in 0.1 seconds. Set Average
anywhere from 0.1 to 300.0 seconds. If Average is set
 to 0.0 seconds, the function is
deactivated.
3. PresstheModebuttonuntiltheCorFLEDislit.IfAveragehasbeenactivated,theAVGLED
willstaylit.
Once Averaging is setabove0, it automatically activates. Note that otherhold functions(like Peak
HoldorValley
Hold)cannotbeusedconcurrently.
6.2.7ValleyHold(VAL)
WithValleyHold,therespectivelastvalleyvalueisheldforthedurationofHoldTime.
Function and setting for valley hold corresponds to the already described Peak Hold function, see
section
6.2.5PeakHold(PKH),p.28.TheValleyHoldfunctionisnotavailablefor2‐colorunits.
6.2.8OverviewtoHoldFunctions
ThefollowingtableliststhevariousHoldfunctionsalongwiththeirresetsandtimingvalues.Usethis
tableasaguideforprogrammingyoursensorandadjustingtheHoldtimes.
Please note, the setting of some commands is not possible by using of the control panel, these
commandsareonlyavailable
bymeansofthesoftware.
Hold Function RESET by Peak Time Valley Time Threshold Hysteresis Decay Rate
Protocol code
P F C XY XE
none none 000.0 000.0 -* -* -*
Peak Hold timer 000.1-299.9 000.0 000.0 -* 000.0
Peak Hold trigger 300.0** 000.0 000.0 -* 000.0
Hot objects moving on a production line
Standard output signal
Average output signal