User manual
Installation
Preinstalled cable
to sensor head
Output signal and
p
ower connector bloc
k
Cable that has to be
installed b
y
the user
Figure6:ConnectingofCablestotheElectronicBox
5. Putthefollowingonthecable(asshowninthefigureabove):
the cap (1), the plastic compression fitting (2), the rubber
washer(3)andoneofthemetalwashers(4).
6. Spread the cable shield (5) and then slip
the second metal
washer(4)onthecable.Notethattheshieldmustmakegood
contacttobothmetalwashers.
7. Slip the wires (6) into the electronic box far enough to
connecttothepowerandoutputterminals.
8. Screw the cap (1) into theelectronics box. Tighten snuggly.
Do
notovertighten.
9. Connectthewires (6)tothepowerandoutputterminals on
theprintedcircuitboard.
MID 17