Vario IP PoE Series Instructions

www.rayteccctv.com 23
Raytec Global Tel: [phone]
Raytec Americas Tel: [phone]
External Output Trigger State : The drop down box gives you the option to disable the
external output signal or make the signal dependant on active states of either the photocell
or External Input or a combination of the two. (Photocell Active State = Darkness. External
Input Active State = Valid Trigger received. )
The External Output active state provided above conditions are met can be selected to be
open/high or closed/low.
Note : External output is triggered by the local lamp Photocell and the local lamp External
Input only.
Factory Defaults: Photocell Only
Factory Defaults: Short Circuit/Low
Photocell Sensitivity
The photocell switch-on level can be altered by using the slider bar.
Levels are:
Minimum level = 5 lux
Maximum level = 65 lux
Factory Defaults: 20 lux
There is a high level of hysteresis and an in-built delay incorporated to avoid switching on/off
in marginal lighting conditions.