Vario IP PoE Series Instructions

www.rayteccctv.com 21
Raytec Global Tel: [phone]
Raytec Americas Tel: [phone]
For the Photocell input, user can select “All Night” in which case the lamp will stay on (if on
command is selected) for the whole period of time that the photocell indicates it is dark.
Alternatively, a specific time period can be selected using the slider bar.
The timer will only operate whilst the photocell indicates it is dark. If the photocell indicates it
is light before the timer has elapsed then the timer is ignored and the light turns off.
For the External Input, user can select “For Duration of Input” in which case the lamp will
stay on or deter (if on or deter command is selected) for the whole period of the duration of
the input.
Alternatively, a specific time period can be selected using the slider bar. The lamps will
operate immediately and the timer duration starts from the end of the External Input signal.
The External Input can be reactivated within the timer period and it will have the effect of
restarting the timer.
The lamp will stay on until the end of the timed period even if the lamp photocell says it is
daylight.
Min and Max timer settings are:
Photocell Min: 30 mins External Input Min: 1 mins
Photocell Max: 720 mins External Input Max: 60 mins
Factory Defaults: Photocell All Night
External Input Duration of Input
Soft Start
There is the option, when a valid on instruction is received, for the lamp to either start
immediately (Soft Start Off) or to ramp up to selected power level (Soft Start On).
The length of time of the ramp up depends on power level selected.(Max 10 seconds for
100% power)
Factory Defaults: Photocell On
External Input Off
Deterrent Pattern & Frequency
There are 3 selectable deterrent patterns available if Deter feature selected from Lamp
Mode on Trigger: