Vario IP PoE Series Instructions

www.rayteccctv.com 12
Raytec Global Tel: [phone]
Raytec Americas Tel: [phone]
Static Network Configuration – Manual allocation of IP address
To use static network configuration it is important that the network administrator controls and
ensures the IP Addresses issued are unique and not repeated. Enter the appropriate IP
Address and Subnet Mask in the “Use the following IP address” section and press “OK”.
The unit will now be allocated the IP Address as entered. Refresh the Discovery Application
by pressing “Discover”.
Name and Group Name
All lamps have the default name of “VARIOIP”. This should be changed so that the lamp can
be easily identified.
The group name is always left blank as default. The group name is used to associate/group
lamps together and allow them to interact using group commands.
Both Name and Group Name can be modified directly from the Discovery Application or via
the web interface.
To change these via the Discovery Application, highlight the lamp you want to change. Then
press “Status”.
Unit Name and Group Name can both be edited by entering a new value in their fields.