User`s manual

Tx Rare (Mbps) It shows the wireless link rate within WDS.

Refresh Click to refresh the statistic counters on the screen.

Close Click to close the current window.

3.3.9 Wireless Mesh Network Settings (only RA-M100Plus)

Mesh network uses wireless media to communicate with other APs, like the

Ethernet does. To do this, you must set these APs in the same channel with the

same Mesh ID. The APs should be under AP+MESH/MESH mode.

This feature is available on RA-M100Plus or firmware u2.3.0.3.R00.

Item Description

Enable Mesh Click the check box to enable Mesh connection to other

Mesh Node devices.

4.35 What is Mesh protocol?

Encryption Select the encryption supported over wireless access. The

encryption method can be None or WPA2 (AES). Refer to

4.16 What is WPA2?

Apply Changes

Click the Apply Changes button to register the AP to new

configuration setting.

Reset

Click the Reset button to abort change and recover the

previous configuration setting.

Set Access

Control

If you choose 'Allowed Listed', only those mesh nodes

whose wireless MAC addresses are in the access control