User`s manual

Note: RA-M100Plus and u2.3.0.3.R00 firmware

support Mesh and AP+Mesh features.

4.22 What is Universal Plug and Play (uPNP)?

Network Type

While Mode is selected to be Client. Click to select

the network type infrastructure or Ad hoc.

SSID It is the wireless network name. The SSID can be 32

bytes long.

Channel Width Select the operating channel width 20 MHz or 40

MHz. [N band only]

Control Sideband Select the Sideband with Upper or Lower for

channel width 40MHz. [N band only]

Channel Number Select the wireless communication channel from

pull-down menu.

Broadcast SSID Click to enable or disable the SSID broadcast

function. Refer to 4.14 What is SSID Broadcast?

WMM Click Enabled/Disabled to init WMM feature.

Data Rate Select the transmission data rate from pull-down

menu. Data rate can be auto-select, 1M to 54Mbps

or MCS. Refer to 4.32 What is Modulation Coding

Schemes (MCS)?

Associated Clients

Click the Show Active Clients button to open Active

Wireless Client Table that shows the MAC address,

transmit-packet, receive-packet and

transmission-rate for each associated wireless

client.

Enable Mac Clone

(Single Ethernet

Client)

Take Laptop NIC MAC address as wireless client

MAC address. [Client Mode only]

Enable Universal

Repeater Mode

Click to enable Universal Repeater Mode

SSID of Extended

Interface

Assign SSID when enables Universal Repeater

Mode.

Apply Changes

Click the Apply Changes button to complete the

new configuration setting.

Reset

Click the Reset button to abort change and recover

the previous configuration setting.