User's Manual

Using the phone adapter for VoIP calls
The phone adapter provides a standard “LINE IN” jack for connecting with a PC. You may talk with your friends on the
Skype (or other IMs such as MSN Message, Yahoo Message, AOL Message) via your Bluetooth headset connected
with the phone adapter.
To use the phone adapter for VoIP calls, do the following:
1. Verify your Bluetooth headset is connected with the phone adapter.
2. Switch the connection of the phone adapter from the PSTN to your PC.
a. Press the TALK button on the headset once.
You will hear a dial tone, and the LED indicator of the phone
adapter is on.
b. Press the TALK button on the headset a second time to hang up.
The LED indicator of the phone adapter flashes twice every
three seconds.
c. Press the TALK button of headset a three time.
The LED indicator of the phone adapter is on again, and the
audio signal is connected between the phone adapter and
your PC sound card. Now you can use the Skype as usual.
Note: If you wish to switch the connection of phone adapter from your PC to the PSTN, press the Talk button on the
headset to suspend the PC sound and do from step 1 on.
LED indicator chart
LED indicator Phone adapter status
Flashing once every three
seconds
Idle mode (Powered on)
Flashing once every one second Pairing mode
Flashing twice every one second Connected mode
Flashing five times every one
second
A call incoming
On (steadily) Call active mode
Paired link to additional devices
Your phone adapter can store pairing information for up to eight different headsets equipped with Bluetooth wireless
technology. If you want to pair the phone adapter and more than one headset, please follow the pairing process to pair
them one by one.
Headset information is stored in a “Paired Device List” in memory in chronological order. When an attempt to pair with
more than eight headsets is made, the oldest paired headset will be removed from the list.
Any of the eight paired headsets can initiate a paired connection to the phone adapter while the phone adapter is in
the idle mode.
The phone adapter will automatically initiate a paired connection (when powered on) with the last headset it was
connected to. When there is an incoming call, the phone adapter can also connect the latest connected headset
automatically while the phone adapter is in the idle mode.
Note: In case the connection is lost, you can manually connect the phone adapter to the headset by pressing the
Enter button.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.