User manual
HEAT EXCHANGERJACKETOTHER
GAS TRAIN
SAFETIES
OPERATING CONTROLS
ASME, National Board Registered, 160 PSI • HLW Stamp
Heat Exchanger Tubes • Cupro Nickel
Bronze Headers
Stainless Steel Condensing Heat Exchanger • U Stamp
Pressure Relief Valve • 125 PSI
(Mounted on Outlet) (Currently Shipped Loose)
Temperature & Pressure Gauge
Pump - Primary • 120V, Single-Phase
Indoor/Outdoor Certified
Vent Terminal • Outdoor
• Through-the-Wall
Fully-Enclosed Controls
Combustible Floor Rated
120V Power Supply with 120V/24V Transformer
On/Off Switch
Programmable Pump Time Delay, Single-Phase • Included in TempTracker Mod Controller
Terminal Block Connections • Enable / Disable
(Front mounted) • External Interlocks
• 0-10 VDC Setpoint/Direct Drive Input
LCD diagnostic display with 16-Event History (2x20 character display, reads in plain English)
Status Display Lights (4)
Temperature Controller with 3 Water Sensors • TempTracker Mod
Multiple Heater Controller • TempTracker Mod+, up to 16 heaters
Hot Surface Ignition System • 1-try
• 3-try
High/Low Gas Pressure Switches
Blocked Vent and Air Pressure Switches
High Limit Switch • Manual Reset, Fixed
• Manual Reset, Adjustable
• Automatic Reset, Adjustable (Shipped Loose)
Low Water Cut-Off, 24V • With Manual Reset and Test Buttons
Flow Switch
Combination Gas Valve
Combustion Air Blower
Additional Safety Valve • Motorized (externally mounted)
• Solenoid (externally mounted)
CSA-Certified Efficiency • 97% at Full Fire
Air Filter
TruSeal Direct-Vent Ready
PVC Vent Adapter Option D-32 (Factory installed only)
Alarm System
CSD-1 / GE GAP Control System
Low NOx • Meets all current requirements
Cold Water Run - Variable Speed Pump • Prevents condensation in primary heat exchanger
WHP
= Standard = Optional
Raypak, Inc. • 2151 Eastman Avenue, Oxnard, CA 93030 • phone: (805) 278-5300 • fax: (800) 872-8725 • www.raypak.com
Cat. No. 6200.12-E Effective 4-1-11 Replaces 1-1-11
6200.12-E_XTherm Brochure 8 page 3/29/11 10:58 AM Page 1