Owner`s manual

4
Support bracket &
fastening hardware
is required.
See page 11.
ONE-PIECE DOOR WITHOUT TRACK
ONE-PIECE DOOR WITH TRACK
Planning
Identify the type and height of your garage door. Survey your garage area to see if any of the conditions below apply
to your installation. Additional materials may be required. You may fi nd it helpful to refer back to this page and the
accompanying illustrations as you proceed with the installation of your opener.
Support bracket &
fastening hardware is
required. See page 11.
Wall
Mounted
Door
Control
Access
Door
Safety Reversing
Sensor
Motor Unit
FINISHED CEILING
FINISHED CEILING
Slack in chain tension is normal
when garage door is closed.
Access
Door
Safety
Reversing
Sensor
Safety Reversing
Sensor
Safety
Reversing
Sensor
Safety
Reversing
Sensor
Gap between fl oor and
bottom of door must not
exceed 1/4" (6 mm).
Gap between fl oor and
bottom of door must
not exceed 1/4" (6 mm).
SECTIONAL DOOR INSTALLATION
Slack in chain
tension is normal
when garage door
is closed.
Wall-Mounted
Door Control
Access
Door
Gap between fl oor and
bottom of door must not
exceed 1/4" (6 mm).
Safety
Reversing
Sensor
Torsion
Spring
Extension
Spring
OR
Motor Unit
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fi berglass, steel, aluminum,
door with glass panels, etc.).
See page 19 for details.
Header Wall
Vertical
Centerline of
Garage Door
Header
Wall
Slack in chain tension
is normal when garage
door is closed.